.............

Press this key until the 2 LEDs light up green and release.
After a few seconds:
• the LEDs light up red and the remote control emits 2 beeps:
The system starts the exit delay. All the detectors of the partition to which the remote control is associated will be activated at the end of the time delay (volumetric and perimeter).
• or the LEDs are flashing green and the remote control does not beep:
The system is not ready to be armed. Check that all doors equipped with a sensor are properly closed. An alarm may also be in memory and need to be cleared by disarming first.

.............

Press this key until the 2 LEDs light up green and release.
After a few seconds:
• the LEDs light up green and the remote control emits 1 beep:
The system and disarm sirens/beeps stopped in case of alarm.
A second press will be necessary in the event of an alarm triggered to clear it before being able to arm the system again.
Disarming the system within the time set by your installer cancels the alert to the remote monitoring center (30s by default).

.............

Press this key until the 2 LEDs light up green and release.
After a few seconds:
• the LEDs light up red and the remote control emits 2 beeps:
Start of the exit delay (without keypad beeps).
All perimeter sensors (doors/windows) of the partition to which the remote control is associated are activated.
No motion sensor (passive infrared) detectors, including those with the "Armed in night mode" option selected, are activated.

.............

Press this key until the 2 LEDs light up green and release.
After a few seconds:
• the LEDs light up green and the remote control emits 1 beep:
This function alerts the remote monitoring center and triggers a local sound alert according to the programming carried out by your installer.
This key may have been programmed for another function by your installer, please consult him/her.